• 榴莲视频IOS污,榴莲视频在线观看污,榴莲APP下载安装,榴莲APP旧版本下载进入官网

    欢迎进入济南济柴榴莲视频IOS污燃气发电设备有限公司官网！

    公司榴莲APP旧版本下载进入官网

    天然气榴莲视频在线观看污发生下面故障怎么处理？

    返回 2020.10.27 来源：http://www.wqeshop.com 0
    一、发动机转速不稳
    1、 Unstable engine speed
    1.执行器与节气门间传动杆系卡滞或间隙大：检查并重新安装调整。
    1. Transmission linkage between actuator and throttle is stuck or clearance is large: check and re install and adjust.
    2.发动机超载：降低发动机负载。
    2. Engine overload: reduce engine load.
    3.转速传感器安装间隙过大：检查并重新安装调整。
    3. The installation clearance of speed sensor is too large: check and re install and adjust.
    4.控制器参数调整不当：重新调整增益、微分及状态开关。
    4. Improper adjustment of controller parameters: readjust gain, differential and state switch.
    5.屏蔽线连接不当，出现电磁干扰产生不稳定：检查屏蔽线是否连接正确可靠。
    5. Improper connection of shielding wire leads to electromagnetic interference instability: check whether the shielding wire is connected correctly and reliably.
    二、发动机不能启动
    2、 The engine will not start
    1、节气门卡死：重新安装与调试。
    1. Throttle stuck: re install and commission.
    2、启动油量设定值过低：适当增大启动油量。
    2. The set value of starting oil is too low: increase the starting oil properly.
    焦化榴莲视频在线观看污
    3、转速设定太低：顺时针旋转低速电位器，以提高到怠速状态。
    3. Speed setting too low: rotate the low speed potentiometer clockwise to increase to idle speed.
    4、无转速反馈信号：检查转速传感器及电缆。
    4. No speed feedback signal: check speed sensor and cable.
    5、调速器电源不通或接反：检查电源及接线。
    5. Governor power failure or reverse connection: check the power supply and wiring.
    三、发动机启动超速
    3、 Engine over speed
    1、控制器参数调整不当：适当增大控制器的“增益”和“微分”。
    1. Improper adjustment of controller parameters: properly increase the "gain" and "differential" of the controller.
    2、调速器电流限制过高：适当降低启动油量。
    2. The current limit of governor is too high: reduce the starting oil properly.
    3、执行器与节气门机构减小燃气的方向不一致或者零点位置不匹配：检查并重新安装调整。
    3. Actuator and throttle mechanism reduce gas direction is inconsistent or zero position does not match: check and re install adjustment.
    4、调速系统转速设定过高：调整低速设定值，达到标定设定值。
    4. Speed control system speed setting too high: adjust the low speed setting value to reach the calibration setting value.
    只有把上述所讲的内容设定好，榴莲视频IOS污的操作才算完成，如果您这边在后续的过程中有任何的问题，欢迎致电或者是在网站上边留言:焦化榴莲视频在线观看污http://www.wqeshop.com
    If you have any problems in the follow-up process, please call or leave a message on the website: coking generator set http://www.wqeshop.com

    上一条：燃气榴莲视频在线观看污如何确保机组可靠运行？

    下一条： 发电机的常见故障有哪些？

    榴莲APP旧版本下载进入官网搜索
    济南济柴榴莲视频IOS污燃气发电设备有限公司

    • 服务热线

      0531-62325028
      0531-69951266

    天然气榴莲视频在线观看污发生下面故障怎么处理？

    一、发动机转速不稳
    1、 Unstable engine speed
    1.执行器与节气门间传动杆系卡滞或间隙大：检查并重新安装调整。
    1. Transmission linkage between actuator and throttle is stuck or clearance is large: check and re install and adjust.
    2.发动机超载：降低发动机负载。
    2. Engine overload: reduce engine load.
    3.转速传感器安装间隙过大：检查并重新安装调整。
    3. The installation clearance of speed sensor is too large: check and re install and adjust.
    4.控制器参数调整不当：重新调整增益、微分及状态开关。
    4. Improper adjustment of controller parameters: readjust gain, differential and state switch.
    5.屏蔽线连接不当，出现电磁干扰产生不稳定：检查屏蔽线是否连接正确可靠。
    5. Improper connection of shielding wire leads to electromagnetic interference instability: check whether the shielding wire is connected correctly and reliably.
    二、发动机不能启动
    2、 The engine will not start
    1、节气门卡死：重新安装与调试。
    1. Throttle stuck: re install and commission.
    2、启动油量设定值过低：适当增大启动油量。
    2. The set value of starting oil is too low: increase the starting oil properly.
    焦化榴莲视频在线观看污
    3、转速设定太低：顺时针旋转低速电位器，以提高到怠速状态。
    3. Speed setting too low: rotate the low speed potentiometer clockwise to increase to idle speed.
    4、无转速反馈信号：检查转速传感器及电缆。
    4. No speed feedback signal: check speed sensor and cable.
    5、调速器电源不通或接反：检查电源及接线。
    5. Governor power failure or reverse connection: check the power supply and wiring.
    三、发动机启动超速
    3、 Engine over speed
    1、控制器参数调整不当：适当增大控制器的“增益”和“微分”。
    1. Improper adjustment of controller parameters: properly increase the "gain" and "differential" of the controller.
    2、调速器电流限制过高：适当降低启动油量。
    2. The current limit of governor is too high: reduce the starting oil properly.
    3、执行器与节气门机构减小燃气的方向不一致或者零点位置不匹配：检查并重新安装调整。
    3. Actuator and throttle mechanism reduce gas direction is inconsistent or zero position does not match: check and re install adjustment.
    4、调速系统转速设定过高：调整低速设定值，达到标定设定值。
    4. Speed control system speed setting too high: adjust the low speed setting value to reach the calibration setting value.
    只有把上述所讲的内容设定好，榴莲视频IOS污的操作才算完成，如果您这边在后续的过程中有任何的问题，欢迎致电或者是在网站上边留言:焦化榴莲视频在线观看污http://www.wqeshop.com
    If you have any problems in the follow-up process, please call or leave a message on the website: coking generator set http://www.wqeshop.com
    网站地图